Welcome to the workshop
All our boards are entirely crafted by hand

here’s a sneak peak to how we do it.

Glueing and Bonding
First of all we spread the glue on our wood layers and place one layer on top the other to create our horizontally laminated board sandwich. The sandwich then goes into the press at high pressure for 24 hours allowing the mould to define the rocker and the bottom contours. When it is ready we release the press and extract the blank board.
Drawing the Outline
We mark the centre line on the blank boards. With the help of pre-cut templates we hand draw the board shape we want. In this process we define the nose and tail type, length and width. Once the drawing is ready, we make a rough cut out of the blank board.
Drawing the Outline
We mark the centre line on the blank boards. With the help of pre-cut templates we hand draw the board shape we want. In this process we define the nose and tail type, length and width. Once the drawing is ready, we make a rough cut out of the blank board.
Cutting and Shaping
We take the rough-cut blank board to the shaping stand and we define its shape using exclusively hand tools. To create the best rail shape we use hand planes, rasps and files.
Carving the Channels
On the bottom of the shaped board we draw the channel placement with the perfect angle. Most of our boards have a quad channel setup that increases their manoeuvrability and edge control. We hand engrave and shape the channels into the bottom layer of the board using sharp chisels.
Carving the Channels
On the bottom of the shaped board we draw the channel placement with the perfect angle. Most of our boards have a quad channel setup that increases their manoeuvrability and edge control. We hand engrave and shape the channels into the bottom layer of the board using sharp chisels.
Treatment and Graphics
We treat all our boards with non-toxic, environmentally friendly, anti-deterioration agents that protect the wood from wear. We apply the protecting agent by hand to ensure it penetrates fully into the wood pores. We brush paint the graphics one by one to give them an extra handmade feel. We only use water based paints that we mix in our lab. We screen print the logo directly on the top layer.
Protection Finish
After completing the graphic and printing the logo we apply several layers of protective top coat for a smooth and clear finish.
Protection Finish
After completing the graphic and printing the logo we apply several layers of protective top coat for a smooth and clear finish.
Custom Boards
Do you want to have a board created directly for you and your specifics?

Go to our custom boards section.